Related posts
Feature
This bn-800 gps has the newest U-M8030-KT chipset for ublox gps. Output frequency is 1Hz-10Hz but 1Hz default.When you use it for Arduino Raspberry Pi, there is no driver needed but you need to install u-center software.
This gps module has flash. So you can save configuration, and do not need to reset next time when you use it.
The TX LED flash means gps module output normally.The PPS LED flash means gps module locate your place.
Its data Level is TTL or RS-232,Default TTL level. To make it be RS232 output, you need to use one TTL to RS232 converter cable
Description
Description:Chipset : u-M8030-KT
Power Supply:DC Voltage 2.8V~6.0V,Typical:3.3V or 5.0V
Consumption:Capture 50mA@5V
Receiving Format: GPS,GLONASS,Galileo,BeiDou,QZSS and SBAS
Receiving Channel:72 Searching Channel
Receiving Sensitivity:Trace -167dBm,Capture-148dBm
Positioning Time:Cold Start: avg26s,Warm Start: avg25s,Hot Start: avg3s
Level Positioning Precision: 2m At Open Wind
Output Frequency:1Hz-10Hz,Default 1Hz
Speed Precision: 0.1 m/s (Without Aid)
Acceleration Precision: 0.1 m/s (Without Aid)
Dynamic Characteristics:Max Height:18000m,Max Speed:515m/s,Max Acceleration:4G
UART Interface:UART Port:TXDA and RXDA
Support Rate:4800bps to 115200bps,Default 9600dps
Working Temperature:-40-+85
Mounting Distance : 30x30mm
Hole Dia. : R1.7mm
Features:
With U-blox M8
Can simultaneously acquire and track different GNSS (Global Navigation
Satellite) system,parallel to receive GPS (QZSS) and GLONASS or BeiDou, or while receiving GLONASS and BeiDou. Specially adapted to the needs to the highest availability and accuracy of high-performance applications, even if is in the GPS signal poor environment.
Equipped with a built-in intelligent automatic switching function.
With long Offline A-GNSS (GPS and GLONASS) function.
Can run simultaneously GPS + GLONASS or GPS +BeiDou
With GPS antenna
Low power consumption
Fast positioning speed
Search to more number of satellites and high positioning accuracy
Notice:
Cable supports mini APM, if it is used for version 2.6 or 2.8,GPS of Pixhawk is needed to change the cable by yourself.
Can not use for flight control with SCM, but it is also suitable for Open source flight controller.
Package Included:
1 x BN-800 GPS Module
1 x Cable