Hobbypower NEO-M8N GPS Module with Compass + GPS Folding Antenna Mount Holder for APM2.8 APM 2.6 Pixhawk PX4 Flight Controller

Related posts

Top 10 best ublox m8 2022

Feature

GPS NEO-M8N with low power consumption and high precision, the ultimate accuracy is 0.6 meters, actually almost 0.9 meters, greater than the previous generation NEO-7N 1.4-1.6 meters accuracy,support GPS/QZSS L1 C/A, GLONASS L10F, BeiDou B1 protocol and mode or more.
Receiver type 72-channel u-blox M8 engine
Built-in compass;It supported antennas Active and passive
Default 5P plug for APM , and comes with a 6P plug ,you can change it for Pixhawk .
If you use the Pixhawk flight controller,you need to add the 6pin connector as picture shows,and when you use and calibrate the compass if you connect to the APM flight controller,you need to remove the jumper wire on APM.

Description

GPS Specs:
- Receiver type 72-channel u-blox M8 engine
- GPS/QZSS L1 C/A, GLONASS L10F, BeiDou B1
- SBAS L1 C/A: WAAS, EGNOS, MSAS
- Galileo-ready E1B/C (NEO-M8N)
- Nav. update rate1 Single GNSS: up to 18 HZ
- Concurrent GNSS: up to 10 Hz
- Position accuracy2 2.0 m CEP
- Acquisition2 Cold starts: 26 s
- Aided starts: 2 s
- Reacquisition: 1.5 s
- Sensitivity2 Tracking & Nav: -167 dBm
- Cold starts: -148 dBm
- Hot starts: -156 dBm
- Assistance AssistNow GNSS Online
- AssistNow GNSS Offline (up to 35 days)3
- AssistNow Autonomous (up to 6 days)
- OMA SUPL & 3GPP compliant
- Oscillator TCXO (NEO-M8N/Q),
- Crystal (NEO-M8M)
- RTC crystal Built-In
- Noise figure On-chip LNA (NEO-M8M). Extra LNA for
- lowest noise figure (NEO-M8N/Q)
- Anti jamming Active CW detection and removal. Extra
- onboard SAW band pass filter (NEO-M8N/Q)
- Memory ROM (NEO-M8M/Q) or Flash (NEO-M8N)
- Supported antennas Active and passive
- Odometer Travelled distance
- Data-logger For position, velocity, and time (NEO-M8N)
- Operating temp. -40 C to 85 C
- Storage temp. -40 C to 85 C (NEO-M8N/Q)
- -40 C to 105 C (NEO-M8M)
- RoHS compliant (lead-free)

Package includes
1x Ublox NEO-M8N GPS Module Built-in Compass

1x GPS bracket Important note:If you use the Pixhawk flight controller,you need to add the 6pin connector as picture shows,and when you use and calibrate the compass if you connect to the APM flight controller,you need to remove the jumper wire on APM.
Please contact me if there is an issue with ths GPS unit,thank you.