Related posts

Feature

A new better GPS optional for APM,it's Super High Precision and Fast Searching Star Efficiency,Position accuracy2 2.0 m CEP
With Low-power, High Precision
This M8N GPS optimize the function module, with Built-in Compass
Supported antenna Active and passive,Supply voltage 1.65 V to 3.6 V
Noise figure On-chip LNA (M8N). Extra LNA for lowest noise figure (M8N/Q)

Description

Mini M8N 8N GPS Chip parameters:
Receiver type 72-channel u-blox Mini M8N engine
GPS/QZSS L1 C/A, GLONASS L10F, BeiDou B1
SBAS L1 C/A: WAAS, EGNOS, MSAS
Galileo-ready E1B/C (M8N)
Nav. update rate1 Single GNSS: up to 18 HZ
Concurrent GNSS: up to 10 Hz
Position accuracy2 2.0 m CEP
Acquisition2 Cold starts: 26 s
Aided starts: 2 s
Reacquisition: 1.5 s
Sensitivity2 Tracking & Nav: -167 dBm
Cold starts: -148 dBm
Hot starts: -156 dBm
Assistance AssistNow GNSS Online
AssistNow GNSS Offline (up to 35 days)3
AssistNow Autonomous (up to 6 days)
OMA SUPL & 3GPP compliant
Oscillator TCXO (M8N/Q),
Crystal (M8M)
RTC crystal Built-In
Noise figure On-chip LNA (M8M). Extra LNA for lowest noise figure (M8N/Q)
Anti jamming Active CW detection and removal. Extra onboard SAW band pass filter (M8N/Q)
Memory ROM (M8M/Q) or Flash (M8N)
Supported antenna Active and passive
Odometer Travelled distance
Data-logger For position, velocity, and time (M8N)

Operating temp. -40 C to 85 C
Storage temp. -40 C to 85 C (M8N/Q) -40 C to 105 C (M8M)
RoHS compliant (lead-free)
Qualification according to ISO 16750
Manufactured and fully tested in ISO/TS 16949 certified production sites
Uses u-blox M8 chips qualified according to AEC-Q100

Supply voltage 1.65 V to 3.6 V (M8N)
2.7 V to 3.6 V (M8N/Q)
Power consumption4 23 mA @ 3.0 V (continuous)
5 mA @ 3.0 V Power Save Mode
(1 Hz, GPS mode only)
Backup Supply 1.4 to 3.6 V

M8N-0 M8N Concurrent GNSS LCC Module, TCXO, flash, SAW, LNA,
Timepulse Configurable 0.25 Hz to 10 MHz

Package including:
- 1 x Mini M8N GPS Module for APM flight controller
Note: The M8N GPS firmware is fixed, so it is no need to revise firmware after you recieved

Note:if you want to use with pixhawk,you need to change 6 pin connector